Fisher-Price B2108 Manual do Utilizador

Discoverwhat’spossible™…www.fisher-price.comModel Number: B2108, B3469Please keep this instruction sheet, as it contains important information.Adult a

IMPORTANT! Before each use, inspect this product for dam-aged hardware, loose joints, missing parts or sharp edges.DO NOT use if any parts are missing

Adjusting the SeatUsing the TrayUsing the Toybar• Lift or lower the toybar for baby's enjoyment.11ToybarAdjust the seat angle in any of three pos

Swing Modes12The Smart Response Swing has two modes: Baby Sounds Activated and Parent Activated .Parent ActivatedIMPORTANT! The maximum weight limit f

Baby Sounds Activated13Sound Sensitivity Dial•Slide the switch to high sensitivity for incomingsounds (listens for shallow sounds).•Slide the switch

Parent Activated14Swing Mode Switch•Slide the switch to parent activated.The power L.E.D.lights and the swing begins swinging.•Be sure to turn the pr

CareStorage•Turn the toybar back to it's storage position.•Press the button on the inside of each housing and push therear legs toward the front

One (1) Year Limited WarrantyFCC Statement (United States Only)Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York14052 warrants that Smart R

Consumer InformationWarnings and Caution2Occasionally a consumer may experience a problem withone of our products. If this should happen, please call

Parts3Front BaseRear BaseSeat with Restraint2 Seat TubesSeat Wire2 Seat WireCaps2 Accessory BinsPadToybar(Toys may be different)Tray2 Front Legs(Longe

•Place the front base on a flat surface.•Position a front leg so that the tapered end is downward,as shown.•While pressing the button on one of the fr

Assembly5•Place the rear base on a flat surface so that the buttons face the front base.•While pressing the buttons on each side of the rear base,fit

Assembly6• Insert four M4 screws through the seat tubes, bracket and into the lock nuts.•Tighten the screws with a Phillips screwdriver.Do not over-ti

Assembly7•While holding the seat wire in place, carefully turn the seat around so that the front faces you.•Position the seat wire cap so that the rou

Assembly8•Fit the pocket on the back of the pad onto the seat back.•Fit the waist belts through the smaller slots in the pad.Crotch BeltWaist BeltsPad

9Assembly Battery Installation and TipsInstallation•Locate the battery compartment door on the swing frame.• Insert a coin into the battery compartmen